Mouser Custom Cabinets Katy, TX

While the glue is dehydrating what the cabinet maker is doing right now on the custom cabinets is he is taking some wood filler and spreading it inside the joints. There are going to be little tiny gaps in the custom cabinets due to the style of wood they inquired and other types depending on the kitchen you're looking for. This is done on purpose because the filler can seal those compartments and it will allow it to breath which is something a lot of people who claim to be cabinet makers don’t know about which makes our certified contractors special. That’s when he is going to bring the custom cabinets over to the sanding table to give it that sparkle. With the wood filler dry on the sides of the custom cabinets the cabinet maker is going to do right now is he has 60 grit paper on the edge sander. All he has to do is just thrust it through the sander and let the machine do the hard work on the custom cabinets. This process would take a typical cabinet maker a lot of extra time so this makes us more effective or sufficient in our work on custom cabinets.  The cabinet maker had to make the pins and tails of the custom cabinets flush together so they could be ready for painting later on. Because the edge sander can leave very fine lines my cabinet maker does is after he runs it through the sander he takes a smaller sander to run it over the custom cabinets just to go that extra mile when going through with all of your products.

Ovation