Next on the middle part or router side of my custom cabinets I am going back the starter screw from earlier and then the rest of the screws on my custom cabinets because now I know where it lines up to the rest of my custom cabinets so it makes it easier to glue the sides together perfectly to one another. Then I will later screw in the rest of them. I lay the glue down and kind of just smear the glue with my finger so it covers the surface of the curve. The makes a good seal for my custom cabinets. I always like to put a lot of glue right where the joints are going to meet especially right at the outer part of the custom cabinets because that’s my outside edge. Now that I already know that my screw is going to line up perfectly for me because I already drilled it I go ahead and drill the screw in. If I want to I can just screw threw the inside curve first and then finish it on the router side of the custom cabinets because it will line up just right. After I screw it in the glue kind of squirts out of the edge and I can just clean that up outside of the inner joints. Finally I can connect that to my custom cabinets using the same method I just described. After I screw in the curves to my custom cabinets I can sand it down to make it look and feel smooth and that completes the back of my custom cabinets. Notice how the wood has a chalk like texture and the island extends extra long to give the kitchen a wide look along the walnut custom cabinets.

Rosewood